Print

[Teamftp]

My 3S lipo will not charge up at all and is giving the following voltage readings when trying to charge.

 4.17v - 1.17v - 4.20v

It was fine and now just says this when trying to charge it?!?!?!

Is it now fubar and about to burst into flame and kill us all?!?!

[Coyote]

FUBAR Simon, the cell has gone too low

[Coyote]

Even if to bring the single cell back to life with the pb charger trick I would say it will fail again if not hold its charge at all

[Teamftp]

Even if to bring the single cell back to life with the pb charger trick I would say it will fail again if not hold its charge at all

Yep tried the PB and it charged up. 45 mins later flat and dead!!!!

[Coyote]

So sad, hope you give it a proper burial

[Teamftp]

So sad, hope you give it a proper burial

Hammer and nail I think!!!

It's only about a month old... Bloody thing!!

[Coyote]

I ressurected two of my new 4S 2200`s after running them too low because of an inaccurate current sensor was telling me I was fine

They came back from the dead, but even though they were holding the voltage per cell after a charge, my flight times were dismal. Paul put them on his expensive tester and they were both epic fails It happens and it sucks

[Teamftp]

Erm it is dead now..

http://youtu.be/7rKJQZawEdQ
	Small | Large