I have taken the KK2 board off my Discovery and I am trying to reinstall the Naza. Unfortunately all I am getting is a CFG-ERR[8] message which, from doing a lot of reading, usually means that a servo wire is reversed somewhere. I have checked them all but they were correct. So far I have done:-
Re bind the Tx/Rx
Checked the TBS board for continuity
Checked all the servo wires for continuity
reassembled everything on the quad
reassembled everything off the quad (rx direct to Naza without TBS top board).
tried new ESC's (DJI's)
tried a different tx/rx (35mhz)
tried a different LiPo
calibrated the IMU
I'm thinking that maybe the Naza has gone duff.
Can anyone think of anything else to try?
As long as all your servo plugs are in upside down ( black to the top ) is pretty hard to reverse anything tbh.
I think CFG-ERR[8] is the Naza is not getting a valid PPM signal
You may need to do a rebind and confirm the RX is working. Just use a servo and 4.8/6v supply wiyhout the Naza in the loop
Other thing is Calibrate and cycle the power to the Naza
Ice
Yep, done both of those.
I knew I missed something of my list.
Got my Naza the other day and had the same error, I recalibrated the sticks and the error cleared.