Simple upgrade has turned into a nightmare - No flying all weekend whilst trying to get it working!
I installed my X8R RX to my Naza v1 via the Sbus connector and have had nothing but problems.
Taranis is binded as an Internal RF D16 CH1-16
Channels setup as follows:-
CH1 - Ail
CH2 - Ele
CH3 - Thr
CH4 - Rud
All channels work fine with exception of CH1 - When stick is centered on the TX, Naza software shows far right. Moving stick to full left centers the Naza slider.
I have tried altering the subtrim yet the Naza will not allow the slider past the center mark.
I have tried calibrating the sticks and gyro yet still the same.
Absolutely stumped!! Any help would be appreciated
Re-binded RX for the umpteenth time and now working - Go figure??
Main thing is that its now working!! :-)