Print Page - EzUHF Binding problem T6EXA

Title: EzUHF Binding problem T6EXA
Post by: dogzilla on March 07, 2012, 10:49:10 PM

Can't bind my EzUHF.

I've followed the binding procedure. When I power the RX and hold down the button the light goes out and stays that way for as long as I hold the button. If I do release the button it sits there for 4-5 seconds then flashes 3 times. Then I power on/off and restart the rx/tx. Then the RX starts and just sits there and occasionally the servo twitches.

Title: Re: EzUHF Binding problem T6EXA
Post by: 6lennn on March 08, 2012, 12:17:19 AM

did mine today, have you been here

http://fpvlab.com/forums/showthread.php?2998-EzUHF-Rx-Tx-bind-procedure (http://fpvlab.com/forums/showthread.php?2998-EzUHF-Rx-Tx-bind-procedure)

are both the tx and rx on the same firmware?

Title: Re: EzUHF Binding problem T6EXA
Post by: 6lennn on March 08, 2012, 12:24:32 AM

read this, someone with the same poblem, same tx

http://fpvlab.com/forums/showthread.php?3375-Binding-procedure-on-EzUHF-TX-Rx-always-fails (http://fpvlab.com/forums/showthread.php?3375-Binding-procedure-on-EzUHF-TX-Rx-always-fails)

FPV HUB

Radio Equipment => UHF Systems => Topic started by: dogzilla on March 07, 2012, 10:49:10 PM