Hi chaps, Probably serves me right but I've just bought a used FY41-lite from an ebay seller and have problems.
I swapped out my working FY41-lite from my FX61 and bunged this one into test it.
When its powered up the usual motor beeps have now gone and I'm just getting one beep every few seconds and no servo operation?
I swapped the old one back and all was good again. I haven't bothered using the power manager that the 2nd hand one came with because mine is obviously exactly the same.
So I bunged the 2nd hand one back in and toggled up the onscreen menu ok. However its impossible to scroll through the menu for some reason?
I had hoped that maybe choosing some other options may spring the servos into life, maybe it is stuck in a flight mode that overides the user's inputs or something.
I'm clutching at straws I know and guess will have to try and return it but I'd like to find a fix if possible :(
beeping like that sounds like your RC transmitter hasn't bound to your receiver, but if its working with your old setup, it must be, I only run the older FY21AP and the FY31AP.
haven't tried the 41.
Hi, Yes exactly, sounds just as if it hasn't bound but I've tried a re-bind and still no go?
Thanks for looking though :)
Quote from: drambuidhe on June 06, 2017, 06:51:22 PM
Hi chaps, Probably serves me right but I've just bought a used FY41-lite from an ebay seller and have problems.
I swapped out my working FY41-lite from my FX61 and bunged this one into test it.
When its powered up the usual motor beeps have now gone and I'm just getting one beep every few seconds and no servo operation?
I swapped the old one back and all was good again. I haven't bothered using the power manager that the 2nd hand one came with because mine is obviously exactly the same.
So I bunged the 2nd hand one back in and toggled up the onscreen menu ok. However its impossible to scroll through the menu for some reason?
I had hoped that maybe choosing some other options may spring the servos into life, maybe it is stuck in a flight mode that overides the user's inputs or something.
I'm clutching at straws I know and guess will have to try and return it but I'd like to find a fix if possible :(
I would connect the AP to the GCS http://www.feiyu-tech.com/Uploads/20161218/585624db5985d.rar (http://www.feiyu-tech.com/Uploads/20161218/585624db5985d.rar) and check through the settings there. See if the parameters for the throttle are not outside the stock settings. This can only be done in GCS not in the OSD menu. If they are then the the AP will not arm. Also check to see that the AP and OSD firmware are compatible as this would not allow the AP to arm. Also boot up in manual mode and re calibrate the esc end points and throttle direction, as that will also stop the AP from arming the motors. If you purchased this from a Futaba user he will have had to reverse the throttle. A quick check would be to try and arm the AP with your throttle all the way open.
hi are you sure that your end points are at 100% on ail and elev I had the same I had dual rates set to 70% and I could not get the cursor to move
hope this helps they are a great controller
rgds