Text only | Text with Images

FPV HUB

Radio Equipment => UHF Systems => Topic started by: wgt40w on March 11, 2012, 10:11:50 PM

Title: EZUHF rx to OSD Batt Sensor RSSI Link Cable
Post by: wgt40w on March 11, 2012, 10:11:50 PM
Have just bought EzUHF Tx & Rx - Both Installed, paired and working ok - BUT

EZUHF Rx has an OSD Link Cable which plugs into rx but the tinned wires at the other end have to be 'spliced' into the EZOSD cable going from Battery Sensor to OSD.
The wire colours are different.
Can someone tell me which colours to splice to which colours - PLEASE.
Title: Re: EZUHF rx to OSD Batt Sensor RSSI Link Cable
Post by: Coyote on March 11, 2012, 11:13:50 PM
Page 15 of your manual : http://www.immersionrc.com/manuals/EzUHFManual.pdf (http://www.immersionrc.com/manuals/EzUHFManual.pdf)
Title: Re: EZUHF rx to OSD Batt Sensor RSSI Link Cable
Post by: wgt40w on March 12, 2012, 01:31:44 PM
Thanks Coyote - I already knew of this, but found it hard to understand. Also I read elsewhere that the Gnd (Black) should NOT be used as planes have been known to crash because of an 'earth loop'.

Being a devout coward I have decided to purchase a ready made lead I found Simon to be selling at -

http://www.firstpersonview.co.uk/rc-control-systems/rc-control-separates/immersionrc-ezuhf-to-ezosd-link-cable (http://www.firstpersonview.co.uk/rc-control-systems/rc-control-separates/immersionrc-ezuhf-to-ezosd-link-cable)
Title: Re: EZUHF rx to OSD Batt Sensor RSSI Link Cable
Post by: Coyote on March 12, 2012, 01:40:47 PM
Lol a good choice :)
Text only | Text with Images