E-flite Opterra Build "edit"

[iwan_canobi]

Yeah, I've had folding props explode on me before, definitely a scary moment so eye protection is a must!

[Njoro]

The print is done but I need to fix a dimension error on my part, otherwise, it printed 1g heavier than the E-flight spinner. If it works out I'll print the final part at a higher resolution which is 0.2mm.

[Njoro]

I just had to run this, I took it to around 75% throttle with a laser point marker; I'm happy to say it held up and didn't need balancing purely because it's so slight it's not worth the hassle. Tomorrow I'll test it at full throttle.

[Njoro]

Printed parts for the dolly













These parts are sliders along the rail they turned out to be very low friction.