x8 Joins the Fleet

[Coyote]

If a scewdriver wont do it no matter what then your looking at drilling the heads off the screws to release it

[Pr][nCe]

or dremel with cutting blade and just lob the top of, once you got the plate of then you should have enough thred to remove the rest with a pair of pliers etc. if need be.

[Teamftp]

Mark,

Check the size of the motor mount, I'm fairly sure this is the one?!?!

If it is I will post it out 1st class tomorrow for you.

Simon

[Big_Red]

Any joy removing those screws fella?

J.

[skyscraper]

Right,

now how the smeg am I going to get these out...

If its superglue or epoxy, could try heating with a big soldering iron!

regards
Andy

[Big_Red]

If you have access to the back of the motor mount (the ply sheet shown in the photo) could you cut around it leaving a circular frame at the edges to attach a new piece of ply then motor mount?

J.