2nd fpv go couple of questions

[jwmachon]

After loosing my first model and equipment I have reordered and upgraded to 600mw vtx

Now a couple of questions I have

1. The new camera is 12v cmq1993x not 5v so what's the way way to wire this through a step up.???

2. I have ordered some clip on ferrite rings where should I place these.???


Many thanks

Hobby

[Tim Chambers]

http://www.firstpersonview.co.uk/accessories/cable-with-step-up-psu-for-wdr700-from-immersionrc-vtx?cPath=41&

[Hubsanman]

Hi Tim

Sorry you lost your model.

You can power the camera and Vtx with a seperate small 3-cell lipo (800-1200Mah)
then there would be no need for any ferrite ring polava. I know its extra weight but its the way I do it.
Way to go. :)

[jwmachon]

I may do that what's the draw rate of the camera and vtx

Thanks

[Tim Chambers]

On my Easystar with a 100mW Vtx, I have been using a 200 mAh 2s lipo.
I've just recently bought a 600 mW Vtx and a 12v camera http://www.firstpersonview.co.uk/cameras/650tvl-0.001lux-3d-dnr-super-mini-camera-with-2.8mm-lens so I bought a step up cable. On this camera I had to change the pins around on the plug but I bench tested with a 200mAh 2s battery. Of course with the higher output of the Vtx I will  use a larger battery in flight.