naza+laptop.

[Ynot6]

just been out with the quad, went to arm, nothing. tried another lipo, nothing, just the 4 flash warning. got back and plugged into my PC, elevator needed trimming! for f$%^sake! so a naza needs a laptop just to find out that the TX is right at the field. out of the box flying my arse. :wallbash:

[MarkLincs]

Once the naza is set up it should not need doing again

[Ynot6]

that's what i thaught, but it needed about 3 clicks of trim on the elevator to get it into the green. that was after i'd done the recalibration. maybe the high temp making the TX or the RX drift?

[Coyote]

Which version Naza and are you using ppm input or PWM ?

[DaveyLC]

How is your naza setup and what version of the firmware are you using?

All of your sub trims on your TX should be at zero.

If you're using a full version Naza V1/2 haven't upgraded to version 3.12 you should do this now.

[Ynot6]

did the upgrade not long ago, naza v1 3.12.

[Ynot6]

set up with standard RX (traditional). sub trims are 0. haven't changed anything exept the batteries (left the TX on)

[Iceman]

When doing the calibration  Make sure you have no trim/subtrim . You sometimes need to exit/disconnect and re-boot Assistant before it saves the Tx offset. 

Occasionally it takes a couple of attempts to be stored correctly on earlier softewares so likely still the same.

Ice

[Ynot6]

just fired it up again. 4 flash warning, offset in assistant. recalibrate, elevator now perfectly centred.  :fool:

[flybywire]

Make sure u calibrate your tx before anything else.  Naza won't like uncalibrated Trany!

[DaveyLC]

You haven't said which version of the firmware you're on? There is a version with a bug that doesn't store the calibration so ever time you power cycle the Naza its lost.

[Ynot6]

i'm on 3.12, which i re-loaded after the bugs had allegedly been sorted. just had it on again, 4 flash warning. plugged into assist, all was well there, then it was fine. going to the turf field anyway, got a plank and my buggy.

[Ynot6]

As I said earlier, what TX are you using? There are a number out there that have historically had issues with the pots, which don't always centre correctly, and that would show up in the way you describe. It's not always a software issue just cause you see it in the software.

dx6i, not a problem with the earlier software. just powered up, 4flash, plugged into pc, all shows well. so i did the upgrade to the latest 3.12 as prompted. i'll have to wait and see.

[Coyote]

This may sound daft, but its not the 4 flsh yellow LED your seeing, which isn't a warning, its the warm up timer that lasts a few minutes is it ?

[Western]

At least you lt can see the colours, I'm colour blind so fooked when it comes to seeing the yellow and green.
Colour blindly yours, Mark