What arrived today?

[BlueFlyer]

Woohoo


Sent from my iPhone using Tapatalk

AAAAAARRGGHH!!!! you must be so excited lol.

nice one, what phone you gonna use in the controller?

[Drone 5]

Stand alone or wired to battery.

[BlueFlyer]

Stand alone or wired to battery.

looks neat, what's wrong with a buzzer on the FC though?

[stevec]

AAAAAARRGGHH!!!! you must be so excited lol.

nice one, what phone you gonna use in the controller?

Had a little test flight in the front garden holy shit! Locked in doesn't even come close. It makes the inspire 1 pro feel unstable.
This thing is going to cause a lot of bad habits to come back in.

Will do a short review in the appropriate section.
Yes I am excited! Even though it is for worki will be taking this everywhere I think😎


Sent from my iPhone using Tapatalk

[BlueFlyer]

Had a little test flight in the front garden holy shit! Locked in doesn't even come close. It makes the inspire 1 pro feel unstable.
This thing is going to cause a lot of bad habits to come back in.

Will do a short review in the appropriate section.
Yes I am excited! Even though it is for worki will be taking this everywhere I think😎


Sent from my iPhone using Tapatalk

I want your job if that's what you get to play with and get paid.

[English Turbines]

ANOTHER Mini Talon...... ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D

   (In case I crash the first one)

 












:vulture:

[BlueFlyer]

nice!
I'd replace that nut with a nyloc one though.

[BlueFlyer]

A few sets of DAL Props to try out, along with a surprise set of free Gemfans.

I've more Props on the way from else where as I fully expect to go through a fair amount of them lol

[Coyote]

DYS ESCs for the 250 quad along with some cable, that lets me finish the power side tonight so I can bolt the lid on :)

[Drone 5]

looks neat, what's wrong with a buzzer on the FC though?

The quad is a Eachine 250 with the cheap box standard Naze 32 board and could not find where to plug one in. The board has integrated plugs. I tried a buzzer plugged into a free channel on the Rx but it did not work. All I can think is the board does not give enough amps to activate the buzzer.

Wanted something quick and what is stand alone.

Can now swap around different airframes with velcro.

Thanks for the comment though.

[BlueFlyer]

New Fatshark (antenna) diversity receiver module, A MenaceRC Invader patch and a MenaceRC Raptor omni.



Along with some more triblade props, 4S 1400mah 65C LiPos and a FrSky XSR receiver.

[Coyote]

Props eventually turned up and a revised GoPro mount off Luvbus :)

[Jake Bullit]

This

[Coyote]

Ah my favorite glider :)

[iwan_canobi]

I'm nearing completion of mine now as well, goes together nicely! Just fighting with getting iNav set up as an AP for it.