There could just be an AXN maiden this afternoon!

[Jake Bullit]

Did you get my text Phil?

[SnoozeDoggyDog]

No mate. Currently battling the Taranis ... for some reason its decided to offset all my sticks to the right ....

You out now?

[Jake Bullit]

Been and gone.

[SnoozeDoggyDog]

Sorry. I still haven't received a text fyi.

A battle of epic proportions persists between myself and the legendary Taranis .... it may continue for 40 days and nights!

[English Turbines]

Sorry. I still haven't received a text fyi.

A battle of epic proportions persists between myself and the legendary Taranis .... it may continue for 40 days and nights!

Better get it sorted then, its 3mph wind tommorow.....PS....why not use the Model creation Wizard built into the TX Firmware....?

:vulture:

[Jake Bullit]

No problem,used the number you gave me in p.m. Can you give it me again,and I`ll check it and we can try again next week .I tried phoning too,maybe I got the number down wrong.

Hope you get Taranis sorted,check the videos by Scott R Page and Mark Harrison.

[SnoozeDoggyDog]

Better get it sorted then, its 3mph wind tommorow.....PS....why not use the Model creation Wizard built into the TX Firmware....?

:vulture:

Long story English. I dicked about with the x9d for a few days so thought I'd factory reset. To cut that story short I thought I'd tweak the default model. Strange problems persisted in as much that no matter what I changed channels 3 and 4 were rudd and ele and the on screen GUI was showing both sticks full right, despite having calibrated. Anyway it's sorted now. I set up a new model on the tx and all is well. Strange that even setting up a model on the companion using wizard still caused the same problems.

P

[SnoozeDoggyDog]

Final checks.....
CG at 45mm from leading edge. Check.
Servos centred, links secure, surfaces flush. Check
Fail safe set. Check
DR and expos to 65% and 25%. Check
20% rud to Ail. Check
Batteries charged
Spare undies
Hot glue .... again.

;D

[FPVSteve]

Are your control surfaces going the right way?

[SnoozeDoggyDog]

Are your control surfaces going the right way?

Hurrys away to garage .......

[Dillwhacker]

Make sure your expo makes it 'soft' in the middle, not 'sharp' in the middle..
£0.02p

[SnoozeDoggyDog]

Let me understand this. If you mean that control input should start slow and build toward the outsides. Yes it does.

Thanks
P

[Dillwhacker]

Let me understand this. If you mean that control input should start slow and build toward the outsides. Yes it does.

Thanks
P

Yep, that's what I mean. Sometimes it seems to get reversed..
Good luck, I hope you have a great flight now - you deserve it !
:P

[SnoozeDoggyDog]

Yep, that's what I mean. Sometimes it seems to get reversed..
Good luck, I hope you have a great flight now - you deserve it !
:P

A pessimist is never disappointed, but thanks man.

[Dillwhacker]

Go steady.
Don't be afraid of altitude.
Get your bearings in the goggles so you know which way is 'home'. Look at the shape of the fields below and make a map in your head.
Don't over react to little wobbles - let the plane fly in the (moving) air - don't try to correct everything.
Fly around gently, and see where that strange person on the ground is, and keep his position in mind.
Then land toward him , into the wind.
You will love it when u get it.
:D