Main Menu

LC Filter

Started by Coyote, December 13, 2010, 07:11:51 PM

Previous topic - Next topic

Pasty

I like the recycle idea... off to the loft for me! :)

Have you tried them yet?

Badlands

#31
Yes - fitted one to my GPS unit (torroid only).

Works really well, sometimes i was waiting 20 mins to get a GPS lock - now from cold i have GPS lock in 90 seconds.




Ive added one to my Steathwing & will report back the results once its finished.


It's all a lot of simple tricks and nonsense...

hpmc

thanks for that coyote i made one and it has improved my video,i will fit one on all now

Coyote

Most welcome, they are really effective arnt they :)
Education and schoolin is good, but FPV is gooder :)

Coyote

Running the whole system from one lipo is in my oppinion better than two. Once its filtered if needed its fine.

I got lost a bit with the rest, do you have diagrams of the more complex filters ? If so then yes please do post them up :)

Which diagram do you want me to post, the one for your system ?
Education and schoolin is good, but FPV is gooder :)

Coyote

Education and schoolin is good, but FPV is gooder :)

ak47

Hi all, ive deceided to put an LC filter in my easystar set up that uses an ezosd.

I will put the ferrite ring in then the capacitor on the power / video in lead. Is there any point adding a ferrite ring on the video out lead to the camera?

Thanks

Ant

MarekM

Quote from: Coyote on April 01, 2011, 10:20:15 PM


Hi,
better will be to use 10-47 nF in place of last 100 uF. Diode - any Schottky type switching diode.

Other idea - in place of ferrite ring - put 10 uH axial inductor with size proper to you current.

Using LC-filters  = 10 uH axial inductors + 10-47 nF capacacitors, are very good and cheap solution for protecting all servo signal lines (specially when you use extending cables).


Marek

RichO:-)

 These filters are good

http://www.flytron.com/70-mickey-1-amper-power-noise-filter.html


Power everything bar escs through one of these. So, basically take power off for all your onboard FPV kit/ BEC after the current sensor through the filter. As with all current sensors do NOT use the GND and + wires, just the current sense output. ;D (big discussion on this by Ren on RC Groups)

mark1975

my my lc filter done today following ian (coyote) mod..cheers ian


I fly alone  (its my only option)
https://www.youtube.com/c/fpvaboveandbeyond?gvnc=
https://plus.goo

Chris R

Here mine for long range Skywalker with 4s 10000mah, tapping 3s power for VTX and Camera.





Coyote

Nice work lads, have you noticed any difference ?
Education and schoolin is good, but FPV is gooder :)

Chris R

Will let you know when tested.  ;)

mark1975

Yeah me too..not had chance to test yet ''but soon.
I fly alone  (its my only option)
https://www.youtube.com/c/fpvaboveandbeyond?gvnc=
https://plus.goo

Chris R

Ok tested LC filter and 99% of interference is gone. :)