Naza M latest update

[Skipper Billy]

It doesn't really 'jump up' its just that the motors do nothing up to 50% then at 51% they all burst into life.

Then it will climb if you open the tap but only just lift off if you stick at 51%

Its just a surprise when the motors do nothing until 50% the all burst into song together.

[Staib]

Yea - no issues to report here either...

I downloaded the new 3.1 Assistant, installed new firmware (via the Assistant) to the FC, and then calibrated the Tx (not that it needed it), and did an advanced IMU calibration (didn't appear to need that either, but I could see no harm in doing it).

Just test flown outside, between rain showers, and despite blustery conditions it flew impressively well.

Takeoff feels a bit different - but then again if half throttle is altitude hold, then logically any climbing (including take off) has to be above 50%... so it makes sense to me.

Medium speed descends seem MUCH steadier - so for me the upgrade is worth it for that added smoothness alone... 

GPS lock also seems tighter than before. It was interesting watching all four motors working overtime to hold position as gusts swept past... :o

Cheers,
Nick

[marcin]

I got this after naza update ...need to power ON couple times before it will go to proper connection ??...IT"S NOT FAILSAFE...as I got 3 switch setup and failsafe is slower yellow flashing then this ?..

any idea ?

Flashing yellow really fast "NOT FAILSAFE" after NAZA upgrade.

[Coyote]

Not sure Marcin, I`m reading a few reports of the new firmware cutting motors when the stick is 40 - 45% while trying to descend, any one else having this issue ?

[JezUK1]

It has changed the way to start the motors with the stick positions. Is there a way to change it?

[Gav]

Decent isn't as wobbly now that's for sure.  Had my throttle stick less than %40 but no cut out.  Might add an 'idle up' setting on my radio, so there's no chance of a cut out just in case :)

Take off is better too.  All good.

[DaveyLC]

Nice looking software but how do you save the calibration changes? :)

[Teamftp]

Nice looking software but how do you save the calibration changes? :)

It is dead easy you just tap enter when you put in the values and it writes it for you.

Simon,

[DaveyLC]

I can't get the CSC to work :(

[3DJIM]

I can't get the CSC to work :(

Did u do the full 6min imu calibration? it wont allow csc unless u have :)


Jim.

[Teamftp]

Ye as above you MUST do the IMU calibration or nothing else will work.

[Ynot6]

just done mine, i found it reasonably straight forward, and i'm c^%p with IT. that double yellow flash on the video clip looks like atti to me. normal without gps. mine does, just the the same as before upgrade. just need some dry weather (drizzling here) not to windy, then i can try it.

[DaveyLC]

I did the advanced Cali :(

[Skipper Billy]

I did the advanced Cali :(

Did you leave it absolutely still until it (advanced IMU cali) completed ??

Mine took 15 minutes to complete.

[ROVguy]

Mine took less than 5 mins to do and although its not been flown I can start everything up ok.