yet another build

[ktnch]

So bought a skywalker last xmas  :o how long ago

finally getting around to get all the parts together and assembled,

mfd, 100amp sens, air speed sens, 70amp esc, ntm 3548 900kv, going to run a twin battery system with a 4s 10,000mah just for the motor and a 3s for everything else

got hold of a new turnigy 9xr pro radio with immersion lrs and lite receiver.

[ktnch]

Got the turnigy mg90s servos, dont think flaps are needed but could add at a later date, bough a sony had 700tvl camera and a 800mw lawnmate tc, rx

[ktnch]

Added some carbon effect vinyl on the leading edges














Just got camera to attach, linkages to sort tx wiring up then jobs about done  :D

[Coyote]

Looks good bud, reminds me of G.Collins monster inspired Skywalker.

[ktnch]

yes liked the look of that, did try to spray an old bixler but looked crap so thought just the edges, apparently if you use lacquer none cellulose that also stops the foam from getting little dings and scratches not sure if its rite tho lol

[English Turbines]

I like the Carbon effect Vinyl......that stuffs usually pretty sticky too......Where did you get that from then...?

:vulture:

[BlueFlyer]

I bet when you've been used to building all those easystars, having the luxury of all that room inside a skywalker makes the build seem easy doesn't it?

Looks good

[SnoozeDoggyDog]

So bought a skywalker last xmas  :o how long ago

finally getting around to get all the parts together and assembled,

mfd, 100amp sens, air speed sens, 70amp esc, ntm 3548 900kv, going to run a twin battery system with a 4s 10,000mah just for the motor and a 3s for everything else

got hold of a new turnigy 9xr pro radio with immersion lrs and lite receiver.

All this wiring detail is just what I'm looking for. Thank you for taking the time to post.

P

[BlueFlyer]

How have you been getting on with this Kev?