SnoozeDogs Mini Talon build and maiden video

[BlueFlyer]

nice, told you it would take it :)

[SnoozeDoggyDog]

nice, told you it would take it :)

It wasnt a hard chuck either. Nice one. And they only cost me £23 each

[BlueFlyer]

It wasnt a hard chuck either. Nice one. And they only cost me £23 each

Yeah, you had to wait an age for them to arrive though lol

[SnoozeDoggyDog]

Yeah, you had to wait an age for them to arrive though lol

They did indeed .... not as long as your motor  :P

[BlueFlyer]

They did indeed .... not as long as your motor  :P

haha, you're right there... some poor bugger on facebook is still waiting for his motor and he ordered his before me lol

[mutley2]

Yep

Same batteries I use, had three at the start of the summer and they are all in good nick after some serious use.
Chuffed the maiden went well, spend time on getting it well dialled in and the RTH sorted before pushing it, MT still has my personal best for distance and has great manners which build confidence and air time.

[SnoozeDoggyDog]

Thx muts. Yep I intend getting things right before any shenanigans occur. But today even with a constantly dipping nose it was still flyable and glided into land from about 300m away. I think it was about a 25mph landing, no issues.

[English Turbines]

Thx muts. Yep I intend getting things right before any shenanigans occur. But today even with a constantly dipping nose it was still flyable and glided into land from about 300m away. I think it was about a 25mph landing, no issues.

Congrats Snooze.....on your MT Maiden.....looked good to me m8....Its good seeing a noob with all the Top Draw components having such obvious success....Well done mate..

Now you are FPV hooked for sure....lol.

    :vulture:

[SnoozeDoggyDog]

Lol ET .... The irony
More to follow. 300ft at about 450m away. New Talon ordered.

[English Turbines]

Lol ET .... The irony
More to follow. 300ft at about 450m away. New Talon ordered.

Awww. Tis but a mere scratch.....pretty sure when you examine it it will glue back again.....I think some steam from the electric kettle might help....That and some decent careful use of the Hotglue Gun.

  Did you loose Video before you had the model flying level and in RTH Mode?..,....I noticed you were a bit low and far out for 5.8G...she covers a lot of ground quick, unlike the old AXN...?

    :vulture:

[FPVSteve]

That#s just a flesh wound - glue her up :) Mine was worse than that when EzUHF stiffed me and it still flies spot on :D

[Coyote]

That's definitely a fixer'uper especially while you are learning how / what order to correctly set things up. Replacing it each times going to get very expensive very quick.

Bit of steam. Bit of glue she'll be reet ;)

[FPVSteve]

Yep - definitely a test bed, just enjoy flying it and learning off it. Rite of Passage for any new airframe :)

[BlueFlyer]

Get that 1.2 gear on it... won't run out of video range in a hurry lol

[Jake Bullit]

On no :( Is there a clue in the aileron angles?