jt's Mini Talon Build.

[jt]

 I pretty much just use ABS now,  I print onto a glass bed coated with ABS slurry. Most things stick perfectly. A thin coat of the slurry for smaller parts and a thicker coating for large area pieces such as this. When I do use PLA I print onto masking tape and clean it off after lol. Never had much success with pritt or hairspray.

[_tj_]

Pritt stick worked good up until I brought this new one.
A small smear onto the glass bed worked well.

I did notice they have brought out another Pritt stick that said "NEW"
A grey colour and super strength.

I guess the grey one is actually the old version, and the other one is modified to wash off kids clothes lol.

Trying pva glue again to print some small things.

Then I'll try the slurry mix.

I can't even try hairspray, I'm allergic to it lol

[jt]

 I used to get a few lifting problems until I used the slurry, I think it is best and of course if you've made it from the same colour ABS it all matches, so no cleaning!  ;D

[_tj_]

Well after 3 attempts at some clips for the Mrs satnav in car.

I made some slurry and tried the 20mm abs cube.
That stuck ok.

Will try the clips again shortly.

[markwilliams]

Hi jt.

Is there any chance you could do me one of those mounts (for bear tokens naturally)?

I have a pan servo just waiting for my Runcam which is probably on the same boat as yout Sunnysky motor.

Mark.

[jt]

Hi jt.

Is there any chance you could do me one of those mounts (for bear tokens naturally)?

I have a pan servo just waiting for my Runcam which is probably on the same boat as yout Sunnysky motor.

Mark.

Yeah, no worries(no need for beer tokens :) )

I've just ordered 2 180 servos from banggood for mine

[markwilliams]

I'll have to give you something.

I can come and collect it whenever you are ready.

Thank you.

Mark.

[jt]

 I'll give you a shout when it's done Mark :D

[_tj_]

Wish me luck.

Just started the longest print run, my printer has ever done.

Made some abs slurry.

Place your bets.
How long into it before it fails.

I'm going 2hrs 25 mins lol

[bignose13]

JT you got a link to the 180 degree servos mate ?
Like the mount, I'll print one off as well
Cheers

[jt]

http://www.banggood.com/JX-Servo-PDI-9180MG-12g-180-Degree-MG-Metal-Gear-Analog-Servo-2_0kg-0_12sec-p-1028941.html    Don't know what they will be like but they are cheap enough lol.

[_tj_]

Currently at 70%
Still printing well.

One hour to go

[jt]

I'll have to give you something.

I can come and collect it whenever you are ready.

Thank you.

Mark.

It's done Mark  ;)

   Johnny

[markwilliams]

Blimey that was quick!

Can I pick it up sometime tomorrow?

You can PM me your address and a convenient time.

Thank you jt.

Mark.

[jt]

  You have PM  :)